GPCA Cargo Cover Installations

For JL 4DR/ 2DR Owners

Step 1: Remove the 6 Torx screws which are holding down the Jeep hard top. Step 2: Insert the included 6 Tie-down D-rings/ D-plates under the bolt, fasten the screws. or use the GPCA Quick Release to replace the factory screws. Step 3: Mount the cover: a. Mount the middle row straps FIRST and align the rollbar base openings to the rollbar base (not the rollbar itself) b. Mount the angled straps next to the back seat gently. Over tighten the 2 straps can cause misalignment from too much pulling. * Soft top owner needs to demount the top pillar to install a pair of D-ring, c. Mount the straps near the tailgate gently. Please balance the cover and DO NOT pull too hard. Make sure the side end panels are resting on top of the plastic base instead of under it. *With a soft top, when it collapses it takes over some cargo space under the tub edge. Before you fold the top, the nearest 2 end-straps need to be adjusted to provide the space needed for the folded soft top. The cargo space is still covered when the soft top is down. Download GPCA JL 4DR Cargo Cover Owner’s Manual PRO / LITE (PDF) Additional steps are required for JL soft top owner (PDF)

For JK 2DR/ 4DR Owners

Step 1: Remove the 6 Torx screws which are holding down the Jeep hard top. Step 2: Insert the included 6 Tie-down D-rings under the washer and the bolt, fasten the screws. or use the GPCA Quick Release to replace the factory screws. hand holds the retainer under the tub edge since it could be shifted unintentionally, align the bolts and holes and secure them. Step 3: Attach the Velcro on the straps (LITE PLUS/ PRO) or snap the hooks on with the logo side up (LITE). Step 4: Adjust the straps (similar to backpack straps) to your desired tightness with care. Download GPCA Jeep Wrangler JKU/ JK Cargo Cover USER MANUAL (PDF): 4DR LITE / 4DR LITE PLUS / 4DR PRO / 2DR LITE PLUS